Lava Computer Computer Hardware LavaPort-Quad User Manual download pdf (Page 16)

Each of the LavaPort-Quad’s four ports incorporates a 64-byte FIFO (first-

in-first-out) buffer.

The FIFO control tabs set the buffer“trigger” levels.When the buffer is

filled to its trigger level with the selected number of bytes, the CPU will

be interrupted and asked to either reload the buffer (for transmission),

or retrieve data from the buffer (for reception).

Most efficient data transmission occurs when the CPU is interrupted

infrequently.For each interrupt,the CPU can then service the buffer with

larger data blocks: during transmission, it can place a large burst of data

into the buffer, and during reception it can retrieve a large block from

the buffer and then continue multi-tasking.

Ideally therefore, Receive triggers should be set as high as possible and

Transmit triggers as low as possible.

However, if the Transmit trigger levels are set too low, or Receive triggers

too high, and the CPU is busy when an interrupt is called by the

LavaPort, a short period of inactivity may occur between the port and

the modem.This will reduce effective transmission/reception speeds.

Optimum buffer settings are dependent on your modem speed, your

CPU speed,and the amount of multi-tasking that occurs while online.

For a fast modem and fast CPU performing few multi-tasking functions,

set transmit triggers low and receive triggers high. If multi-tasking while

online,set transmit triggers higher and receive triggers lower.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Lava Computer Computer Hardware LavaPort-Quad User Manual Page 16